Table of Contents
Advertisement
Available languages
Available languages
Using this unit
Selecting a source
1 Press SRC/OFF to cycle between:
! Keep the battery out of the reach of children.
TUNER (tuner) CD (CD player) USB (USB)/
iPod (iPod) Apps (Smartphone App) SD
(SD memory card) AUX (AUX) BT Audio
! Batteries (battery pack or batteries installed)
(BT audio)
Adjusting the volume
1 Turn M.C. to adjust the volume.
! Use one CR2025 (3 V) lithium battery.
CAUTION
! Remove the battery if the remote control is
For safety reasons, park your vehicle when re-
moving the front panel.
! There is a danger of explosion if the battery is
Note
When this unit s blue/white lead is connected to
! Do not handle the battery with metallic tools.
the vehicle s auto-antenna relay control termi-
! Do not store the battery with metallic ob-
nal, the vehicle s antenna extends when this
unit s source is turned on. To retract the anten-
! If the battery leaks, wipe the remote control
na, turn the source off.
! When disposing of used batteries, comply
Use and care of the remote
control
Using the remote control
1 Point the remote control in the direction of the
! Do not store the remote control in high tem-
front panel to operate.
When using for the first time, pull out the film
! The remote control may not function properly
protruding from the tray.
! Do not let the remote control fall onto the
Replacing the battery
1 Slide the tray out on the back of the remote
control.
2 Insert the battery with the plus (+) and minus
( ) poles aligned properly.
Frequently used menu
WARNING
operations
Should the battery be swallowed, consult a
doctor immediately.
must not be exposed to excessive heat such
as sunshine, fire or the like.
CAUTION
not used for a month or longer.
incorrectly replaced. Replace only with the
same or equivalent type.
jects.
Tuner
completely clean and install a new battery.
Basic operations
with governmental regulations or environ-
mental public institutions rules that apply in
your country/area.
Important
peratures or direct sunlight.
in direct sunlight.
floor, where it may become jammed under
the brake or accelerator pedal.
1 Band indicator
Using this unit
2 News indicator
3 Traffic Announce indicator
4 5 (stereo) indicator
5 Preset number indicator
Returning to the previous display
6 LOC indicator
Returning to the previous list/category (the folder/
category one level higher)
7 Signal level indicator
1 Press
/DISP.
8 TEXT indicator
Returning to the ordinary display
9 PTY label indicator
1 Press BAND/ .
a Program service name
Returning to the ordinary display from the list/cat-
b Frequency indicator
egory
1 Press BAND/ .
Selecting a band
1 Press BAND/
Selecting a function or list
1 Turn M.C. or LEVER.
! In this manual, Turn M.C. is used to describe
Manual tuning (step by step)
the operation used to select a function or list.
1 Turn LEVER.
! Select Manual (manual tuning) under Tuning
Switching preset stations
1 Turn LEVER.
1
23
4
5
6
7
! Select Preset (preset channel) under Tuning
Seeking
8 9
a
1 Turn and hold down LEVER.
RDS
1
23
4
5
6
7
Using PI Seek
If the tuner cannot find a suitable station, or the
reception status deteriorates, the unit automati-
8
b
cally searches for a different station with the
same programming. During the search, PI SEEK
Non-RDS or AM
is displayed and the sound is muted.
Section
02
Appears when local seek tuning is on.
Shows when the radio text is received.
until the desired band (FM-1,
FM-2,FM-3 for FM or AM) is displayed.
Mode to use this function. For details about
the settings, refer to Tuning Mode (LEVER tun-
ing setting) on page 9.
Mode to use this function. For details about
the settings, refer to Tuning Mode (LEVER tun-
ing setting) on page 9.
! While turning and holding down LEVER,
you can skip stations. Seek tuning starts
as soon as you release LEVER.
7
En
Advertisement
Table of Contents
