Software; Force Recovery Mode - Avermedia TN111B Manual

2. Using the commands below in the Linux PC to start re-flashing BSP.
$ sudo tar zxvf EN715-R1.0.*.tar.gz
(file: EN715-R1.0.*.tar.gz for NO111B/ file: EN715-NX-R1.0.*.tar.gz for NX211B)
$ cd JetPack_*.**/Linux_for_Tegra
$ sudo ./flash.sh Jetson-nano-emmc mmcblk0p1
(For the Xavier NX module:
$ sudo ./flash.sh Jetson-xavier-nx-devkit-emmc mmcblk0p1)
Note: sudo is required to re-flash the BSP.

5.0 Software

For L4T (Linux for Tegra) BSP support and the other software support associated with
NVIDIA® Jetson Nano / TX2 NX/ Xavier NX , please visit AVerMedia website to contact our
technical support function. (https://www.avermedia.com/tw/support/contact)

6.0 Force Recovery Mode

USB 3.l/OTG(Micro USB) port of NO111B/TN111B/NX211B can be used to re-program
®
NVIDIA Jetson NANO/TX2 NX/Xavier NX by using the other host system running NVIDIA
Jetpack, as the procedure described below.
1. Power off the system. Ensure the system power must be completely OFF, instead of staying
in the suspend mode or the sleep mode.
2. Connect a USB cable from OTG(Micro USB) USB port to the other host system which will
be used to re-program the new system file into NVIDIA
NX.
3. Press and hold down Force Recovery
4. After three seconds, release Force Recovery Button.
®
5. NVIDIA NANO/TX2 NX/Xavier NX will show up on the USB list of the host system as a
new NVIDIA target device.
6. After the system software is updated successfully, please ensure to power off the system. A
clean power-on will then revert OTG(Micro USB) port back to the host mode.
NO111B_TN111B_NX211B User Manual
®
Button and then power on the carrier board.
31
AVerMedia Technologies, Inc
Jetson NANO/TX2 NX/Xavier
www.avermedia.com