Table of Contents
Advertisement
4.0 Installation
1.
Check and
ensure all the external system power supplies are turned off.
2. Install the Micro USB2.0 cable to OTG(Micro USB) connector.
3. Press and hold on the Recover button.
4. Connect the power cord to the box PC.
BSP (board support package) file: EN715-R1.0.*.tar.gz for NO111B
BSP (board support package) file: EN715-NX-R1.0.*.tar.gz for NX211B
https://www.avermedia.com/professional/download/en715#parentHorizontalTab2
Default login username/password of the BSP is nvidia/nvidia
If you have difficulties to access the BSP download link, please visit AVerMedia website at
https://www.avermedia.com/professional/download, or contact technical support at
https://www.avermedia.com/professional/technical_support or e-mail us at
eusupport@avermedia.com for further assistance.
BSP Installation steps for NVIDIA Jetson board: (Important Note: Please backup your
personal files before re-flashing BSP)
After you download the BSP file and put the file in a Linux PC, please refer to the steps below
to re-flash BSP.
1. Let the JETSON Nano/TX2 NX/Xavier NX initiate recovery mode.
You have to keep pressing "Recovery" button and then power on the NVIDIA Jetson board
to initiate recovery mode.
When connecting a NVIDIA Jetson board to a Linux PC via a MicroUSB to USB cable, you
can check kernel messages with `dmesg` command in the Linux PC.
Once you see these messages in the kernel messages, this means that the NVIDIA Jetson
board is in the recovery mode.
[24685.229129] usb 1-7: Product: APX
[24685.229132] usb 1-7: Manufacturer: NVIDIA Corp
NO111B_TN111B_NX211B User Manual
4.1 BSP Setup Instructions
30
AVerMedia Technologies, Inc
www.avermedia.com
Advertisement
Table of Contents
