Safety Rules; General - Promax DT-800 Manual

CONTROL MODULE. DT-800

2. SAFETY RULES

2.1 General

*
The safety could not be assured if the instructions for use are not closely
followed.
*
Use this equipment connected only to systems with their negative of
measurement connected to ground potential or isolated from the network.
*
This is a Class I equipment, for safety reasons plug it to a supply line with the
corresponding ground terminal.
*
This equipment can be used in Overvoltage Category II installations and
Pollution Degree 1 environments.
*
When using some of the following accessories use only the specified ones to
ensure safety.
Power cord.
*
Observe all specified ratings both of supply and measurement.
*
Remember that voltages higher than 70 V DC or 33 V AC rms are dangerous.
*
Use this instrument under the specified environmental conditions.
*
The user is not allowed to perform changes inside the equipment. Any change
on the equipment must be done exclusively by specialized staff.
*
When using the power adaptor, the negative of measurement is at ground
potential.
*
Do not obstruct the ventilation system of the instrument.
*
Use appropriate low-level radiation cables for Input / output signals, especially
on high level signals.
*
Remote configuration cables <3m.
*
Follow the cleaning instructions described in the Maintenance paragraph.
04-2012 Page 3