Table of Contents
Advertisement
CONTROL MODULE. DT-800
4.3 LEDs Table
The LEDs of each module indicate a certain status depending on the colour.
The LEDs are placed on the front panel of the module.
In the case of a dual module, there will be two columns of LEDs, one per each
module.
Name
Status
GREEN
ON
OFF
GREEN
ERROR
RED
RED
IP
INTERMITTENT
OFF
GREEN
TS-IN
RED
GREEN
DVB-T
RED
PROGRAM
INTERMITTENT GREEN
ASYNCHRONOUS
INTERMITTENT GREEN
OFF
GREEN
LOCKED
RED
GREEN
SERVICE LIST
RED
TS-OUT
GREEN
RED
GREEN
A/V
RED
GREEN
MUX
RED
4.4 DT-800 Starting Up
Turn on your computer through the switch, which is placed on the rear panel of
the module [9].
04-2012
Description
The module is receiving voltage and
working.
Off / Does not work.
It is working properly.
There is an error in the process.
There is not Ethernet connection.
Ethernet connection established but there
is not data traffic to the module.
Ethernet connection established and there
is data traffic to the module.
Transport Stream received correctly.
There is a problem in the reception of the
Transport Stream (too fast, TS wrong...).
DVB-T output signal is correct.
Problem at the output.
DT-800 is programming the unit.
The
communication from the module for more
than 60 seconds.
No programming.
Locked signal.
It was not posible to tune.
Service List detected.
It was not able to read the service list.
Proper TS output.
Problems at the TS output.
Audio and video processing is working
properly.
Error during the process / Encoder broke
down.
Proper Multiplexing.
Error during multiplexig. / Multiplexer broke
down.
Table 2.-Table of LEDs description.
DT-800
have
not
received
Page 13
Advertisement
Table of Contents
