Display Of Preset Output - Siemens LME71 Series Basic Documentation

Note:

Display is possible only when ...


A
A
1...3 s
A
>3 s
Smart Infrastructure
15.4.4

Display of preset output

in operating mode or standby,
program sequence for modulating operation via analog preset output.
Basic Documentation LME7...
15 Operation via internal LED
A
Press for display of the relative current position of the
actuator.
Signal lamp blinks green.
Display shows .oP.
A
Press (1...3 seconds) for display of the relative current
position.
Signal lamp blinks green.
The relative value .57 of the current position is displayed.
PME7 with actuator
control:
Position of actuator 0°
0  value of potentiometer =
0% display
Position of actuator high-fire
>0°
<90° = value of
potentiometer
<1000  = 100% display
>0  <1000 
Example: Value .57
+
When pressing for >3 seconds, the point after the
number begins to blink.
When the button is released, the value is displayed for 2
minutes.
Signal lamp blinks green.
Then, the normal display appears.
Display: Value 57, point . blinks.
PME7 with PWM fan:
Current speed
0 rpm = 0% display
Current speed corresponds
to the rated load speed =
100% display
103/116
CC1P7105en
24.07.2020