Troubleshooting - Panasonic NA-128VG6 Operating & Installation Instructions Manual

Troubleshooting

Problem
Buttons do not
work
Door does not
open
Unusual odour
No water going
into the appliance
Water builds up
during a wash
Water drains out
during a wash
30
Cause and Measures
- Settings cannot be changed while an operation is
in progress. Only the spin speed and "Extra Rinse"
settings can be changed when the wash process is
paused.
- The Child Lock (
- The door is locked while an operation is in progress.
(P. 14)
- The Child Lock (
- The temperature inside the drum may be very high.
- The water level may be too high.
To open the door immediately
(1) Switch the appliance off and then on again.
(2) Run the Spin operation (P. 24). After the water is
drained and the temperature falls, you can open the
door.
- If you switch off the appliance or there is a power cut
while the door is locked, it remains locked until the
power is turned on again.
-
the appliance, but the smell will go away over time.
- Run the "Tub Clean" programme to clean the drum.
(P. 28)
- The tap may be turned off.
- The water supply may be disrupted.
- The water supply hose may be frozen. (P. 27)
-
- This is normal. Water is automatically supplied if the
water level falls.
- If there is excess foam, water is drained out and fresh
water supplied to remove the foam. This is the foam
detection function.
- Even if water is directly supplied to the drum, it may
drain away without building up.
) may be activated. (P. 26)
) may be activated. (P. 26)