Panasonic NA-128VG6 Operating & Installation Instructions Manual page 32

Troubleshooting
Problem
Fabric softener
There is powdered
detergent left on
the laundry after
washing
There is an
unusual noise or
vibration
There is noise
when water drains
out
There is a fan
rotation sound.
There is a power
cut during
operation
The circuit breaker
trips during
operation
The water supply
is disrupted
The display is
unclear
32
(continued)
Cause and Measures
- The amount of softener used may have been above the
"MAX" line in the detergent drawer. (P. 12)
- The detergent drawer may have been closed too
strongly and spilt some of the softener.
- Powdered detergent may have been put directly into
the drum.
It should be put into the detergent drawer. (P. 12)
- There may be a metal item in the drum.
- The anchor bolts may not have been removed.
( P. 36)
- The appliance may be installed on a slope or an
unstable surface.
- Wet clothes may be loaded at the start of washing.
Perform spin process or wring out the laundry
beforehand.
- This is normal. It is the noise of the drain pump
working.
- This is normal. The fan cools electric parts.
- Operation will resume from the point it had stopped
when the power is recovered. (Auto restart)
- Figure out the cause and deal with it, then reset the
breaker.
Operation will resume from the point it had stopped
when the power is recovered. (Auto restart)
- After the water supply is restored, the water may be
discoloured for a short while.
Disconnect the water supply hose, run the tap until
the water is no longer discoloured, and reconnect the
water supply hose. (P. 38)
- The appliance may be in a brightly lit or sunlit area.