Panasonic NA-128VG6 Operating & Installation Instructions Manual page 31

Problem
Water is not
supplied to the
drum during the
rinse process
Rinsing begins
before the spin
During the spin
process, the drum
stops and rotates
several times
Foam or water
remains on the
door or door seal
The displayed
remaining time
changes
There is not
enough/too much
foam
Cause and Measures
- Before rinsing, the appliance spins to drain out any
- If the appliance detects an unbalanced load, it
automatically starts rinsing to correct the imbalance.
- If excess foam remains after washing, the water is
the foam detection function.
- This is normal. When the appliance detects an
unbalanced load, it automatically tries to correct it.
- The laundry may be too light.
Try adding one or two bath towels.
- Some foam or water may remain depending on the
state of the laundry or the amount of detergent used.
Wipe foam or water away before taking out the laundry.
- The display is only a guide and is corrected continually.
- The remaining time may increase if the rinse or spin
settings are changed or if the appliance detects an
unbalanced load and makes an adjustment accordingly.
- The amount of foam varies depending on the
temperature, level and softness of the water.
The following can result in less foam
- Powdered detergent may have been put directly into
the drum.
It should be put into the detergent drawer. (P. 12)
- Too little detergent may have been used.
- Low foam detergent may be used.
- The laundry may be heavily soiled.
- The load may be large.
The following can result in more foam
- Too much detergent may have been used.
31