Speaker Distance; The Input Assign Menu - Pioneer HTP-075 Operating Instructions Manual

5
5
5
Adjust the level of each channel using
If you selected Manual, use / to switch speakers.
The Auto setup will output test tones in the order shown
on-screen:
1c.Channel Level
Front L 0dB
Center [ 0dB]
Front R [ 0dB]
Surround R [ 0dB]
Surround L [ 0dB]
Subwoofer [ 0dB]
Return
Adjust the level of each speaker as the test tone is
emitted.
Note
• If you are using a Sound Pressure Level (SPL) meter, take
the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighting/slow
reading).
• The subwoofer test tone is output at low volumes. You
may need to adjust the level after testing with an actual
soundtrack.
6
When you're finished, press RETURN.
You return to the Channel Level menu.

Speaker Distance

For good sound depth from your system, you need to specify
the distance of your speakers from the listening position. The
receiver can then add the proper delay needed for effective
surround sound.
• For the assignment of the digital signal inputs, see
Selecting the audio input signal on page
1
. Select 'Manual SP Setup' from the Home Menu.
/
2
Select 'Speaker Distance' from the Manual SP Setup
menu.
3
Adjust the distance of each speaker using
(For the U.S.A., Canada and Latin America models)
You can adjust the distance of each speaker in 0.1 ft.
increments.
(For the other models)
16.
You can adjust the distance of each speaker in 0.1 m
increments.
4
When you're finished, press RETURN.
You return to the Manual SP Setup menu.
1.Manual SP Setup
a.Speaker Setting
b.X.Over
c.Channel Level
d.Speaker Distance
Return
.
/
1d.Speaker Distance
Front L 10.0 ft
Center [ 10.0 ft ]
Front R [ 10.0 ft ]
Surround R [ 10.0 ft ]
Surround L [ 10.0 ft ]
Subwoofer [ 10.0 ft ]
Return
1d.Speaker Distance
Front L 3.0 m
Center [ 3.0 m ]
Front R [ 3.0 m ]
Surround R [ 3.0 m ]
Surround L [ 3.0 m ]
Subwoofer [ 3.0 m ]
Return
31

The Input Assign menu

(CD) audio input terminal is assigned to CD under factory
settings, but this can be changed to TV input.
1
Select 'Input Assign' from the Home Menu.
Home Menu
1.Manual SP Setup
2.Input Assign
3.Auto Power Down
4.HDMI Setup
Return
2
Select 'Analog Input' from the Input Assign menu.
2a.Analog Input
2.Input Assign
a.Analog Input Analog
Return
3
Select the desired input option for the (CD) audio input
terminal.
4
When you're finished, press RETURN.
You return to the Input Assign menu.
Home Menu
2
4
34
CD
Return