Advertisement
AG35 CANTILEVER UMBRELLA
This umbrella is not a permanent shade structure and must be lowered when unattended or in
windy conditions. Excessive wind puts stress on the frame, which can cause damage to the
umbrella and danger to people. This umbrella is not recommended for exposed environments
such as high balconies or roof tops. Do not install on sloping or soft ground. Please carefully
read the following instructions; if in doubt, consult a qualified trades-person. Only use
recommended Shelta bases or anchoring systems.
To ensure a long life for your AG35 Cantilever umbrella:
Close the umbrella and cover with the Protective Sleeve between uses.
•
•
Store in a dry, shaded location if not used for long periods.
•
The umbrella should be hosed regularly with fresh water if exposed to salt spray chlorine or pollution.
Soiling of the canopy can be minimised by simply brushing off dirt before it becomes embedded in the fabric
•
or spot cleaning soon after stains occur. Fabrics may be treated with a fabric protector such as 'Scotchguard'
for additional protection.
Do not close or store the umbrella when wet; if it is necessary to close a wet umbrella in stormy weather,
•
remember to open and dry the canopy as soon as weather conditions allow.
Every 6 months spray the Rotate Bearing and Ballast Block Frame with WD40 or deoderised fish-oil.
•
Regularly check that the base of the umbrella is properly secured.
•
Important Safety Information
www.shelta.com.au
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for shelta AG35
Summary of Contents for shelta AG35
- Page 1 Only use recommended Shelta bases or anchoring systems. To ensure a long life for your AG35 Cantilever umbrella: Close the umbrella and cover with the Protective Sleeve between uses.
- Page 2 AG35 Components After unpacking the carton, please make sure that you have the following parts: COMPONENT AG35 Side-post and Umbrella Protective Sleeve Ballast Block Frames Rotate Bearing (in some cases attached to the side-post) Onground Plate Parts Bag (including Handle and spanners)
- Page 3 Installing and operating the AG35 Umbrella Up to date instructions and installation clearance measurements can be found at https://shelta.com.au/cantilever-installation/ The AG35 umbrella frame is heavy and is best handled by 2 people; take care not to soil or damage the canopy by contacting nearby structures.
- Page 4 Shelta Warranty Shelta Australia will, at their discretion repair, refinish, replace, replace with a similar product or refund the product. Only the failed item will be replaced, not a complete setting. The Shelta Warranty period is not extended in the event of a replacement.
Need help?
Do you have a question about the AG35 and is the answer not in the manual?
Questions and answers