shelta AG5A Quick Start Manual

shelta AG5A Quick Start Manual

Cantilever umbrella
Hide thumbs Also See for AG5A:

Advertisement

AG5A CANTILEVER UMBRELLA
This umbrella is not a permanent shade structure and must be lowered when unattended or
in windy conditions. Excessive wind puts stress on the frame, which can cause damage to
the umbrella and danger to people. This umbrella is not recommended for exposed environ-
ments such as high balconies or roof tops. Do not install on sloping or soft ground. Please
carefully read the following instructions; if in doubt, consult a qualified trades-person. Only
use recommended Shelta bases or anchoring systems.
To ensure a long life for your AG5A Cantilever umbrella:
Close the umbrella and cover with the Protective Sleeve between uses.
Store in a dry, shaded location if not used for long periods.
The umbrella should be hosed regularly with fresh water if exposed to salt spray or pollution.
Soiling of the canopy can be minimised by simply brushing off dirt before it becomes embedded in the
fabric or spot cleaning soon after stains occur. Fabrics may be treated with a fabric protector such as
'Scotchguard' for additional protection.
Do not close or store the umbrella when wet; if it is necessary to close a wet umbrella in stormy weather,
remember to open and dry the canopy as soon as weather conditions allow.
Every 6 months spray the Rotate Bearing and Ballast Block Frame with WD40 or deoderised fish-oil.
Regularly check that the base of the umbrella is properly secured.

Important Safety Information

www.shelta.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AG5A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for shelta AG5A

  • Page 1 Only use recommended Shelta bases or anchoring systems. To ensure a long life for your AG5A Cantilever umbrella:  Close the umbrella and cover with the Protective Sleeve between uses.
  • Page 2 AG5A Components After unpacking the carton, please make sure that you have the following parts: COMPONENT AG5A Side-post and Umbrella Protective Sleeve Lower Side-post Ballast Block Frames Rotate Bearing Onground Plate Screws 23mm and allan key Screws 20mm and washers...
  • Page 3 Suitable for most surfaces including grass. This should be ballasted with between 110 and 140 kilograms of weight. Purchase at least 6 Shelta Resinstone Ballast Weights or concrete pavers (45 x 45 x 4cm) from your outdoor retailer or hardware.
  • Page 4 Shelta Warranty Shelta Australia will, at their discretion repair, refinish, replace, replace with a similar product or refund the product. Only the failed item will be replaced, not a complete setting. The Shelta Warranty period is not extended in the event of a replacement.

Table of Contents