Table of Contents
Advertisement
Installing A Pump With Bulk Tubing
This section is for you if you ordered your Well Wizard® components and tubing
unassembled, The following sections tell you how to assemble the components and
tubing.
Getting Ready
It's important to not contaminate pump components. Doing so can degrade the
quality of the samples obtained using your Well Wizard system. Always wear latex
gloves when unpacking and installing Well Wizard components, and any other time
when your hands might touch a water-contacting component.
Install the Inlet Screen
Well Wizard bladder pumps have a 10 year warranty that is valid only if you use the
appropriate inlet screen.
There are two types of inlet screen: One that you thread onto the pump inlet for 1100
series pumps, and one that you secure with set screws for 1200 and 1300 series pumps.
The correct screen for each pump is usually included with the other components for
the well - the box label tells you where to find the screen. The following sections
describe how to install the two types of inlet screens.
Screens For 1100 Series Pumps
To install a screen on an 1100 series pump, follow these steps:
1.
Still wearing the latex gloves, open the plastic wrapping, then remove the screen.
2. Thread the screen onto the male-threaded pump inlet, making sure the screen is
firmly tight.
Screens For 1200 and 1300 Series Pumps
To install a screen on an 1200 & 1300 series pump, follow these steps:
1.
Still wearing the latex gloves, open the plastic wrapping, then remove from the
bag both the screen and the small plastic bag that contains spare set screws and a
small Allen wrench.
2. Find the groove around the inlet end of the stainless steel pump body
(the end opposite the air and water connectors), then slide the screen onto the
bottom of the pump assembly, aligning the top rim of the screen with the top groove.
Well Wizard®
Installation and Operation Manual
Rev. A 2-1-2018
Page
12
Advertisement
Table of Contents
