Table of Contents
Advertisement
Caution: Make sure that you don't bring the tubing or other pump components
in contact with the ground or any other surface. It's often helpful to spread out a
polypropylene tarp next to the well during installation.
1.
Still wearing the latex gloves, if you have a protected well cap, mark any necessary
information - such as well ID and depth - on the label inside the well cap.
2. Slowly lower the pump into the well while uncoiling the tubing bundle, until the
entire length of tubing is in the well. Be sure to control the rate of descent. Do not
let the tubing free fall into the well.
3. An optional support cable is available for the ST1102 and ST1102M pumps, and for
all deep well applications on all sampling pump models.
Attaching Tubing to the Well Cap
To attach tubing to the well cap, follow the instructions included with the shipment
for the appropriate well cap.
Well Wizard®
Installing The Sampling Pump
Installation and Operation Manual
Rev. A 2-1-2018
Page
11
Advertisement
Table of Contents
