Table of Contents
Advertisement
Install the Inlet Screen
Well Wizard bladder pumps have a 10 year warranty that is valid only if you use the
appropriate inlet screen.
There are two types of inlet screens: One that you thread onto the pump inlet for 1100
series pumps, and one that you secure with set screws for 1200 and 1300 series pumps.
The correct screen for each pump is usually included with the other components for
the well - the box label tells you where to find the screen. The following sections
describe how to install the two types of inlet screens.
Screens For 1100 Series Pumps
To install a screen on an 1100 series pump, follow these steps:
1.
Still wearing the latex gloves, open the plastic wrapping, then remove the screen.
2. Thread the screen onto the male-threaded pump inlet, making sure the screen is
firmly tight.
Screens For 1200 and 1300 Series Pumps
To install a screen on an 1200 & 1300 series pump, follow these steps:
1.
Still wearing the latex gloves, open the plastic wrapping, then remove from the
bag both the screen and the small plastic bag that contains spare set screws and
a small Allen wrench.
2. Find the groove around the inlet end of the stainless steel pump body
(the end opposite the air and water connectors), then slide the screen onto the
bottom of the pump assembly, aligning the top rim of the screen with
the top groove.
Note: If you have difficulty installing the screen, use the Allen wrench to loosen the
set screws a little.
3. Using the Allen wrench, lightly tighten each of the set screws, then make sure the
screws have engaged the groove.
4. Using the Allen wrench, firmly tighten each of the set screws.
5. Check to make sure the screen is secure.
Well Wizard®
Installing the Inlet Screen
Installation and Operation Manual
Rev. A 2-1-2018
Page
10
Advertisement
Table of Contents
