Table of Contents
Advertisement
Portable Components
Portable Well Wizard® components include a cycle controller, water level meter,
disposable sample filters, and a flow-through cell.
Controller
A controller controls operation of the Well Wizard pump by regulating the air flow
from a compressed-gas source to the pump. When connected to an appropriate
compressed-gas source, the controller alternately pressurizes then vents the air
supply line to the pump, allowing the pump to discharge and then fill with water.
For more information, please refer to the operation and installation manuals for the
individual controllers.
Water Level Meter
The model MP30 drawdown/water level meter can be connected to the QED cycle
controllers to automatically control the drawdown during purging and sampling.
The series 6000 electronic water-level meters use a portable conductivity probe
attached to a calibrated tape. There is a light and audio signal when the probe
touches the water surface.
Flow Cell
The MP20 is QED's optional flow cell. The MP20 lets you know when it's okay to sample
- generally saving you from spending a lot of time and from removing large volumes
of purge water. The MP20 signals when stabilization has been achieved for selected
water parameters.
QuickFilter®
To ensure accurate samples of dissolved metals, you can use an optional QED
QuickFilter. It removes solids larger than 0.45 micron. Because QuickFilters are
disposable - you use one for each sampling event - there's no need to try to clean or
decontaminate the filter from well to well.
Page
8
Well Wizard®
Installation and Operation Manual
Rev. A 2-1-2018
Advertisement
Table of Contents
