Raid Configuration Utility; Bios Setup Utility; Warranty And Rma - CompuLab MicroSVR Owner's Manual

Table of Contents

Advertisement

RAID configuration utility

The RAID option must be enabled in BIOS before the system can load the Intel® RAID Option ROM
code.
1.
During boot, enter the BIOS setup by pressing F2.
2.
Go to Advanced > Drive Configuration.
3.
Set Configure SATA As to RAID.
4.
Press F10 to save setting and exit the BIOS Setup program.
At boot time the RAID configuration utility can be invoked by pressing <CTRL-I> (Control I) key
combination.
The Raid configuration utility is made by Intel. It it documented in:
Technology (Intel® RST) user

BIOS Setup Utility

Entering BIOS Setup Utility
Turn off the MicroSVR.
Turn on while holding down the F2 key.
Additional BIOS information or updates can be found in:
http://fit-pc.com/wiki/index.php/IntensePC:_BIOS_Documentation

Warranty and RMA

Warranty
CompuLab guarantees products against defects in workmanship and material for a period of 24
months from the date of shipment.
Your sole remedy and CompuLab's sole liability shall be for CompuLab, at its sole discretion, to
either repair or replace the defective product at no charge.
This warranty is void if the product has been altered or damaged by accident, misuse or abuse.
RMA
Keep the original package for shipping in case of hardware failure.
In case of HW failure of an MicroSVR under warranty, please contact the seller of that MicroSVR.
Please provide the following required information:
MicroSVR serial number
Name of purchaser
Address
Problem description
If the MicroSVR was purchased directly from CompuLab, please email rma@fit-pc.com.
guide" which can be downloaded from the intel web site.
8
"Intel® Rapid Storage

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MicroSVR and is the answer not in the manual?

Related Products for CompuLab MicroSVR

Table of Contents