Sophos XGS 2U Series Mounting Instructions

Sliding Rails Mounting Instructions

XGS 2U Series
The XGS 2U series slide rails are designed and built for 1U and 2U chassis and not recommended for use
with a 3U chassis. The rails fit into EIA racks with a 5/8" pitch and square holes.

Step 1: Remove the appliance rail

Pull the slide open. Then pull the lock forward (1)
and pull out the inner appliance rail.
Push the trigger (2) and push the outer piece back
into the rack rail (3)

Step 2: Attach the appliance rail to the chassis

Mount the appliance rails on each side of the
appliance by aligning the holes over the studs and
pushing them backwards until you hear a click.

Step 3: Attach the rack rails to the rack

Disengage the safety lock before you attach the rack
rails to the rack. Insert each rack rail into the holes on
the rack from the inner side of the front (1) and rear
(2) mounting posts. Push the safety lock forward to
secure the rack rails until you hear a click.
Use a round-head screw to secure the rack rail to the
front of the rack.

Step 4: Mount the appliance into the rack

Pull the rack rails open until you hear a click. It is
important to check if the ball bearing retainer is locked
forward. Otherwise it could cause very serious damage
to the chassis while mounting.
Move the appliance half way into the rack rails (4a).
While you are pushing chassis back to the cabinet,
you need to release the slide from locking position by
pulling the release tab (4b).
United Kingdom and Worldwide Sales
Tel: +44 (0)8447 671131
Email: sales@sophos.com
© Copyright 2020. Sophos Ltd. All rights reserved.
Sophos is the registered trademark of Sophos Ltd.
North American Sales
Toll Free: 1-866-866-2802
Email: nasales@sophos.com
1.
Appliance rail
3.
1.
1. 2.
Click
2.
1.
Click
3.
1.
2.
4a.
1.
4b.
Australia and New Zealand Sales
Tel: +61 2 9409 9100
Email: sales@sophos.com.au
2.
Outer member
Rack rail
2.
2.
Asia Sales
Tel: +65 62244168
Email: salesasia@sophos.com
20-07-31 (DD)