Advertisement
SET UP THE UDRC58HD CAMERA
Basic steps to install and set up the UDRC58HD camera are:
1. Pair the UDRC58HD camera to the UDR system.
2. Install the UDRC58HD camera
3. Set UDRC58HD camera paramaters.
PAIR UDRC58HD TO UDR SYSTEM
Pair the camera to the monitor before you install it. Once the camera is paired,
the monitor displays live video from it. This live video will help you position the
camera for the best viewing angle.
# Cameras that come with your system are pre-paired at the factory. Use the
following pairing procedures to pair accessory cameras or to change the
channel location of existing cameras (for example, move the camera on
channel 1 to channel 4).
Tap the following icons as they
appear on the monitor screens:
1. Attach the camera's antenna and plug the camera into power.
2. Tap
Pairing
on the
Camera Setup
3. Tap the channel number you want to pair the camera to.
4. A message displays with instructions to press the
A 30-second countdown begins. Press and release the
back of the camera.
# You must press the PAIR button on the back of the camera during the
30-second countdown; otherwise, the camera will not be paired.
5. The system displays live video 3 seconds after the camera is successfully
paired.
INSTALL THE UDRC58HD
When you are positioning the camera, bring the monitor along; it's much easier
to find the best viewing angle when you have the display handy.
# The monitor's battery will last about 2 hours on its own.
1. Position the camera where you want it, plug it into power, pair it if necessary,
and check video on the monitor. Move the camera if the view is not what you
want.
2. Hold the base of the camera stand where you want to mount it and mark the
location of the screw holes.
3. Use the included screws and anchors to attach the base to the wall or ceiling.
4. Tug gently on the stand to make sure it is securely in place.
This screen should display:
screen.
PAIR
6
button on the camera.
button on the
PAIR
Advertisement
