Electrolux TWGL3E301 User Manual page 23

Error code
Internal fail. No communication
between electronic elements of
the appliance.
E97
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
The tumble dryer is not connec‐
ted to the mains supply.
The door is open.
The tumble dry‐
The
er does not op‐
was not pushed.
erate.
The
not touched.
The appliance is in standby
mode.
Possible cause
Possible cause
On/Off (Ein/Aus) button
Start/Pause button was
Remedy
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
Close the door.
Push the On/Off (Ein/Aus)
button.
Touch the Start/Pause but‐
ton.
Push the On/Off (Ein/Aus)
button.
ENGLISH 23