Audio Settings - Sanyo DVP2902 User Manual

C

Audio settings

Choose the appropriate audio settings for your device. It only affects the sound during DVD playback. Follow steps 1 and 2 on
page 16.
3
Select the desired item.
<Audio menu>
HDMI Audio 8
System
Night Mode
Language
Audio
Video
0
Preference
Note(s):
Audio Out:
– Bitstream:
Connecting to a Dolby Digital decoder for Dolby Digital audio output.
The multi-channel audio signals are output from HDMI OUT jack with Bitstream or LPCM.
– PCM:
Connecting to another device (an MD deck or DAT deck etc.) without a Dolby Digital decoder.
Convert the Dolby Digital into LPCM (2 channel).
• This unit does not support DTS audio. This is not a malfunction.
You need to set this unit to "Bitstream" in the "HDMI Audio" Menu and also need to connect to a TV or amplifier that
supports DTS, then the audio will be output as DTS.
It is only available when connected via a HDMI cable.
• "HDMI Audio" cannot be configured when voice guide is set to on, as it is fixed to PCM. In order to configuring the
setting, set voice guide to off.
EN
4
HDMI Audio: (Default: PCM)
Set to "Bitstream" when the unit is connected to a Dolby
Digital decoder.
– Bitstream: outputs a Dolby Digital signals.
– PCM: convert the Dolby Digital into PCM (2 channel).
HDMI Audio Bitstream
Night Mode PCM
e
Night Mode (Default: 0)
Adjusts for clarity even when the volume is Low, by
compressing the range of the lowest sound level and the
highest sound level.
HDMI Audio 8
Night Mode
ge
0
nce
– 19 –
Select the desired
setting.
5
To exit the menu