Kenwood KUF55X18 Installation Instructions Manual page 8

installation
1. Remove the two screws from the back of the top
cover, then lift the top cover and place it on a padded
surface to prevent from scratching.
2. Remove the four screws (2 from each side). Remove
the upper hinge. Lift the door and place it on a
padded surface to prevent from scratching.
3. Lay down the unit. Remove both levelling feet, and
bottom hinge. Swap their position.
Before transferring the bottom hinge to the
other side, move the bottom hinge pin from
hole 1 to 2. Tighten the pin securely.
4. Stand the unit. Place the bottom hole of the door
onto the bottom hinge pin. Insert the upper hinge
pin into the upper hole of the door. Screw the upper
hinge tightly. Screw also the other side tightly.
Ensure the door is aligned horizontally and
vertically, so that the seals are closed on all
sides before finally tightening the hinge.
8
Bottom
hinge pin
①
②