Steps
1. Connect the USH daughter board FPC cable from USH daughter board.
2. Place the USH daughter board with the FPC cable in the slot on the system.
3. Replace the two (M1.2x2.5) screws securing the USH daughter board to the palm-rest assembly
4. Adhere the USH daughter board FPC cable to the keyboard.
5. Gently connect the power button with fingerprint reader FPC cable to the connector on the USH daughter board.
Next steps
1. Install the
system board
2. Install the
I/O daughter
3. Install the battery.
4. Install the
display
assembly.
5. Install the
heat
sink.
6. Install the
WWAN
card.
7. Install the
base
cover.
8. Install the
SIM card
tray.
9. Install the
SD
card.
10. Follow the procedure in
Wireless Wide Area Network (WWAN) Antenna
module
Removing the WWAN main antenna module
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the
WWAN
card.
.
board.
After working on your
computer.
before working inside your
tray.
computer.
Removing and installing components
53