Steps
1. Align and place the system fan onto the palm-rest assembly.
2. Replace the two (M1.6x2.5) screws that secure the system fan to the palm-rest assembly.
3. Connect the system fan cable to the connector on the system board.
4. Adhere the single piece of tape securing the system fan cable to the system board.
Next steps
1. Install the
base
cover.
2. Install the
SIM card
tray.
3. Install the
SD
card.
4. Exit
service
mode.
5. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
SIM card
4. Enter
service
mode.
5. Remove the
base
cover.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
After working on your
computer.
before working inside your
tray.
computer.
Removing and installing components
27