Thermostat Control; Safety Feature - Pelonis CH1001 User Manual

Turn the power and setting switch to your desired heat settings:
•
1 ~ 700W
2 ~ 900W
3 ~ 1500W
The power light will remain illuminated during operation.
•
control

THERMOSTAT CONTROL

Turn the thermostat control clockwise to the highest position to start heater.
•
Allow heater to operate and warm up the room.
When the desired temperature/comfort level is reached, lower the temperature
•
setting by turning the Thermostat Control counter-clockwise until the heater
stops operating.
The thermostat will automatically maintain the pre-set temperature level by
•
turning the heat ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling, raise the temperature setting.

SAFETY FEATURE

Thermal cut-off: This heater includes a thermal cut-off that shuts the heater off if it
overheats due to abnormal conditions. If this occurs, turn the heater off, unplug it,
inspect and remove any objects on or adjacent to the heater. Allow it to cool for a
few minutes, and then plug it back in and resume normal operation.
This is not a defect！
Tip over switch:This heater includes a safety tip over switch, which will shut the
heater off in case it is tipped over. If at any time, the heater does tip over, please
place the heater back in the upright position. The heater will resume its normal
operation.
3
power and setting