Connecting To An Ac Power Source - Cisco Catalyst PON Series Hardware Installation Manual

Connecting to an AC Power Source

Warning
Connecting to an AC Power Source
Warning Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Before you begin
Prior to connecting the power supply to a power source, ensure that the ONT is properly grounded.
Procedure
Step 1
Plug the power cable into the power connector on the ONT.
Figure 14: Connecting an AC Power Cable to the CGP-ONT-4PVC
Step 2
Plug the other end of the power cable into a power source.
Step 3 Verify that the power supply is receiving power by checking whether the PWR LED is green.
Note
Cisco Catalyst PON Series Switches Hardware Installation Guide
28
To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 3 in.
(7.6 cm). Statement 1076
If the LED does not turn on, check the power connections on the power supply and the power source.
Installation