Cisco Catalyst PON Series Hardware Installation Manual page 51

Removing and Replacing Field-Replaceable Units (FRUs)
Note
Step 3 Secure the power supply module as follows:
• On the front of CGP-OLT-8T, use the Phillips head screwdriver and tighten the captive installation screws
on the power supply module to the power supply bay.
• On the rear of CGP-OLT-16T, use the Phillips head screwdriver and tighten the two captive installation
screws on the power supply module to the power supply bay.
What to do next
You can proceed with either of the following actions:
• Connect an AC power source, see
• Connect a DC power source, see
Ensure that the text on the power supply module is facing up while inserting the power supply
module. The antireverse structure of the power supply module prevents you from inserting it in the
reverse direction.
Connecting to an AC Power
Connecting to a DC Power Source.
Cisco Catalyst PON Series Switches Hardware Installation Guide
Inserting the Power Supply Module in an OLT
Source.
47