Fan Belt; Adjusting Fan Belt Tension - Kubota V3300-E Operator's Manual

26 PERIODIC SERVICE

FAN BELT

BAdjusting fan belt tension
CAUTION
To avoid personal injury:
A Be sure to stop the engine and
remove the key before checking the
belt tension.
A Be sure to reinstall the detached
safety shield after maintenance or
checking.
A deflection of between 10 to 12 mm
Proper fan belt
(0.39 to 0.47 in.) when the belt is
tension
pressed in the middle of the span.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt between the
pulleys.
3. If tension is incorrect, loosen the alternator mounting
bolts and, using a lever placed between the
alternator and the engine block, pull the alternator
out until the deflection of the belt falls within
acceptable limits.
4. Replace fan belt if it is damaged.
A If belt is loosen or damaged and the fan is damaged,
it could result in overheats or insufficient charging.
Correct or replace belt.
[V3307-DI-TE]
(1) Fan belt (A) 10 to 12 mm (0.39 to 0.47 in.)
(2) Bolt and nut (under load of 10kgf (22 lbs))
[V3300-E, V3300-TE, V3300-DI-E, V3300-DI-TE,
V3800-DI-E, V3800-DI-TE, V3300-EBG, V3300-T-EBG]
(1) Fan belt (A) 10 to 12 mm (0.39 to 0.47 in.)
(2) Bolt and nut (under load of 6~7 kgf
(13.2~15.4 lbs))