ADTRAN NETVANTA 7000 Series Quick Start Manual page 4

R F
ESTORING ACTORY
On units that have a console port, to restore the factory defaults you must enter the factory-default command
from the unit's Enable mode prompt. For example, enter the command as follows:
>enable
#factory-default
The factory-default command should be used with caution. For more information on
how to restore the NetVanta 7000 Series unit to the factory defaults using this
command, refer to article number 2608, Factory Defaulting the NetVanta 7000 Series
Products, available online at http://kb.adtran.com.
P E
OWER OVER
Power over Ethernet (PoE) technology provides the ability to detect attached powered devices (PDs) and
deliver 48 VDC to the PD using existing CAT 5 cabling. The NetVanta 7000 Series units are fully compliant with
the power delivery options called out in the IEEE 802.3af PoE specification. By default, the PoE interfaces
discover and provide power to IEEE-compliant PDs.
To disable power detection and supply, use the power inline never command in the CLI. To disable power
detection and supply from the GUI, select the Ports page. Then select a single port from the list (e.g., eth 0/1).
This will bring up the port detail page for eth 0/1. On this page, there is a check box to enable power detection.
N V B
ET ANTA USINESS
If your NetVanta 7000 Series unit is part of the NetVanta Business Communications System (a bundle of
NetVanta 7000 Series products and the NetVanta Unified Communications server), you must configure your
NetVanta 7000 Series unit to communicate with the UC server, and you must configure the UC server to
recognize the NetVanta 7000 Series unit. Instructions for configuring both the UC server and the NetVanta 7000
Series unit for use with the NetVanta Business Communications System are available online in the Configuring
the NetVanta Business Communications System quick configuration guide at http://kb.adtran.com.
4
D
EFAULTS
THERNET
C
OMMUNICATIONS
Copyright © 2010 ADTRAN, Inc. All Rights Reserved.
S
YSTEM