Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Phonic MAX Series
Summary of Contents for Phonic MAX Series
- Page 2 Use damp cloth or dry brush to clean the unit. DO NOT use any other solvents for cleaning. Good care and maintenance of your unit will prolong your unit’s operational life and insure its optimal performance. Page 2 MAX SERIES USER’ S MANUAL PHONIC CORPORATION...
-
Page 3: Table Of Contents
S P E C I F I C AT I O N S ........1 4 4 POWER SWITCH..........7 SYSTEM BLOCK DIAGRAM.....15 5 POWER LED..........7 6 PEAK LED..........7 7 SIGNAL LED..........7 8 GAIN CONTROLS........7 PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 3... -
Page 4: Introduction
INTRODUCTION / FEATURES / GETTING STARTED INTRODUCTION GETTING STARTED Thank you for purchasing a Max series power am- Check the AC voltage before connecting the power plifier. Based on years of experience in designing plug to the outlet. Make sure the AC power sup-... -
Page 5: Installation
Leave 1-rack space between power amplifiers to guarantee better cooling (See Figure PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 5... -
Page 6: Connections
BRIDGE MONO (See Figure 3). connection (See Figure 2). 3 OUTPUT Binding posts and speakon connectors make up the unit’s output section. Loudspeakers can eas- ily be connected using banana plugs, spade lugs, Page 6 MAX SERIES USER’ S MANUAL PHONIC CORPORATION... -
Page 7: Operation
A minimum level of independent gain controls. So the two channels -30dBu is required for the LED to go on. sharing the same signal do not share the same output level (See Figure 4). PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 7... - Page 8 OPERATION Page 8 MAX SERIES USER’ S MANUAL PHONIC CORPORATION...
- Page 9 One channel for driving low fre- channels (See Figure 5). quencies while the other for driving high frequen- A) When one channel is assigned for left channel, cies. make sure the other channel is assigned for PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 9...
- Page 10 PIN 1+ as the “+” and PIN needed to prevent experiencing electric shock. 2+ as the “-”; when using binding posts, treat Chan- nel 1 + as the “+” and Channel 2 + as the “-”. Do Page 10 MAX SERIES USER’ S MANUAL PHONIC CORPORATION...
-
Page 11: High Pass Filter
“grounding on” position. When grounding loop and hum occur, try switching to “floating.” When the hum is gone, it means the common ground is on the other equipment. PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 11... -
Page 12: Protections
POWER ON / OFF MUTING: There is a two to three second delay before the unit sends out any signal. During this 2-3 seconds, the system will be on mute, no signal exist this unit. Page 12 MAX SERIES USER’ S MANUAL PHONIC CORPORATION... -
Page 13: Dimensions
DIMENSIONS DIMENSIONS MAX series share the same dimensions. Measurements are shown in mm/inch. PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 13... -
Page 14: S P E C I F I C At I O N
SPECIFICATIONS SPECIFICATIONS All specifications are subject to change without notice. Page 14 MAX SERIES USER’ S MANUAL PHONIC CORPORATION... -
Page 15: System Block Diagram
SYSTEM BLOCK DIAGRAM SYSTEM BL STEM BL STEM BL STEM BL STEM BLOCK DIA OCK DIA OCK DIA OCK DIAGRAM OCK DIA GRAM GRAM GRAM GRAM PHONIC CORPORATION MAX SERIES USER’ S MANUAL Page 15...
Need help?
Do you have a question about the MAX Series and is the answer not in the manual?
Questions and answers