Table of Contents
Advertisement
Network settings
1
Press
and use
to Select Setup, then press OK.
2
Use
to Select Network settings, then press OK.
3
Adjust the following items.
Manual network settings
1
Use
to Select Manual network settings, then press OK.
Manual network settings
Network selection
Connection test
Wireless network setting
Setting status
IP configuration
Home network
Proxy configuration
Wake-on-LAN(DIAL)
Net TV
Reset network settings
Network selection
2
Use
to Select Network selection, then press OK.
3
Use
to Select the desired setting, then press OK.
If you connect to an Ethernet Cable, select Wired
Wired
to connect to the Internet.
If you have a router with easy connect function,
Wireless
select Wireless to connect to the Internet.
Wireless network setting
This menu is displayed only when you set Wireless in Network selection.
In order to use a wireless network, you must set up a connection to the
AP (e.g. Wireless Router).
2
Use
to Select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use
to Select Auto, then press OK.
4
The list of wireless networks will be displayed. Use
appropriate the SSID, then press OK.
Auto
Router 1
Manually enter your SSID
Router 2
Router 3
Router 4
•
If you select the SSID with
appear. Enter the WEP
/ others key of the selected wireless
*2
network using
, then press OK.
•
If you select the SSID has an easy connect, the easy connect setting
screen will appear. Use
to Select the
Easy Connect
Pin code
Manual
, WEP
/ others Key entry screen will
*2
to Select a setting, then press OK.
Select this Setting if your Router has an easy
connect button. Start Scanning for wireless
networks on the TV after pressing the easy
Easy Connect
connect button on your Router. If Connection Test
fails, try Easy Connect again.
to the Router's Manual for more details.
Select this Setting if your Router has an easy
connect feature but does not have an easy
Pin code
connect button. Enter the 8-digit PIN code shown
on your TV in the Router settings menu via PC
before Connect is selected.
If your wireless network with authentication setting
(WEP
, others), WEP
*2
will appear. Enter the WEP
Manual
selected wireless network using
press OK.
*1
Easy Connect cannot be used when the security protocol is set to
WEP. Change the Access Point's security mode from WEP to others
(recommended).
WEP is not recommended to be used due to its Major security flaws.
*2
Change the Security protocol on the Wireless Router to others
(recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
•
For a wireless network with authentication setting, key icon appears to the right hand of the
SSID.
•
Signal icon shows the strength of the signal.
•
WEP
/ others key appears as asterisks on the confirmation screen.
*2
•
The wireless LAN supports following specifications.
–Wireless standards: IEEE 802.1 1 b/g/n
–Frequency spectrum: 2.4GHz
–Security protocol: WEP
/ others
*2
38
.
English
If it fails then refer
*1
/ others Key entry screen
*2
/ others key of the
*2
, then
Continued on next page.
Advertisement
Table of Contents
