Table of Contents
Advertisement
Search for channels
Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
1
Press
and use
to Select Setup, then press OK.
2
Use
to Select Search for channels, then press OK.
3
Use
to Select Start, then press OK.
Install channels
You can search and store all channels. If you move the unit to a different
area after the initial setting, it is recommended to perform
Autoprogramming.
4
Use
to Select Antenna or Cable, then press OK.
5
Press OK on Start.
•
When the Scanning and Memorizing of Available Channels is
Completed, the Lowest Memorized Channel will be Displayed.
6
Follow the On-screen Instructions to Complete the Installation.
System searching. Please
wait...
Auto programming may take
more than 20 minutes to
complete.
12
Stop
Channel settings
1
Press
and use
to Select Setup, then press OK.
2
Use
to Select Channel settings, then press OK.
3
Adjust the following items.
Channel installation
Weak channel installation
Child lock
Installation mode
Change PIN
Uninstall channels
Digital audio language
Mono/Stereo
Digital channels found:
0
Analog channels found:
0
Total progress:
3
4
Channel installation
Be sure the RF cable is correctly connected to this Unit and you are
registered with your Cable TV provider when you Install Cable channels.
Weak channel installation
This function lets you add the channels that were not added by the
AutoProgram due to the reception conditions during the initial setup. It is
available only when you select Antenna in Installation mode.
1
Use
to Select Channel installation, then press OK.
2
Use
to Select Weak channel installation, then press OK.
3
Use
to Select Search, then press OK.
•
The PIN code will be required if you have locked channels.
4
Use
to Select a channel you want to memorize.
5
Use
to Select Search, then press OK.
6
Display will be changed to Store from Search when the channel is
found, then press OK.
Note(s)
•
In most cases, Digital channels are not broadcast on the RF channel on which they appear on
your TV. To add Digital channels you need to know the RF channel on which the Digital channel
is being broadcast. (e.g. If there is a Digital channel 9.1 which is being broadcast on RF channel
25, you need to enter 25 while performing a weak channel installation.) To find out the RF
channel on which a particular Digital channel is being broadcast, please contact your local
service provider. Installing Digital channels using Weak channel installation might not work for
direct cable connections and if the Digital signal is too weak for the TV to process.
Installation mode
1
Use
to Select Channel installation, then press OK.
2
Use
to Select Installation mode, then press OK.
3
Use
to Select Antenna or Cable, then press OK.
•
When Antenna is selected, the TV detects antenna signals. It
searches for DTV and Analog TV channels available in your area.
•
When Cable is selected, the TV detects signals supplied by cable.
It searches for DTV, Analog TV and Cable channels available in your
area.
Uninstall channels
The channels selected here can be skipped when selecting the channels
using CH + / –.
Those channels can still be selected with the NUMBER buttons.
1
Use
to Select Channel installation, then press OK.
2
Use
to Select Uninstall channels, then press OK.
3
Use
to Select the channel you want to remove, then press OK.
•
The removed channels are not displayed on the list of Favorite
channels.
•
To reactivate a removed channel, use
34
.
English
then press OK.
Continued on next page.
Advertisement
Table of Contents
