Useful Tips; Faq - Philips 32PFL3901 User Manual

6 Useful tips

FAQ

Question
•
•
•
•
My Remote Control does not
work.
•
What should I do?
•
•
•
How come the Initial Setup
•
appears every time I Turn On
this Unit?
•
•
•
Why can I not watch some RF
•
signal TV Programs?
•
•
•
How come there is no image
•
from the Connected External
•
Devices?
•
When I enter a channel
number, why does it change
Automatically?
Why are captions not
•
displayed Entirely?
Or why are captions delayed
behind the dialog?
•
How can I set the clock?
My PIN code no longer
•
works, how can I change the
Child Lock setting?
When I start up the TV or a
•
net service, a message
appears on the screen
prompting for software
update again.
Check the Antenna or Cable Connection to the Main Unit.
Check the Batteries on the Remote Control.
Check if there is an obstacle between the infrared sensor window and the Remote Control.
Test the IR Signal Output use IR Signal Check.
If okay, then possible Infrared Sensor trouble.
Aim the Remote Control directly at the infrared sensor window on the front of the Unit.
Reduce the distance to the Unit.
Re-insert or replace the AAA Batteries with their Polarities (+/–) as indicated on the Remote Control Battery area.
When there is an infrared-equipped device such as PC near this Unit, it may interrupt the Remote Control signal on this
Unit. Move the infrared-equipped device away from this Unit, change the angle of the Device's infrared sensor or Turn Off
the infrared communication function.
Make sure to complete the Initial Setup before the Unit goes into Standby mode.
Autoprogram must be completed when you Set Up the Unit for the First time or Move it to a location where previously
unavailable channels are broadcast.
Make sure Auto programming has been completed.
The selected channel may not be broadcasting.
When Auto programming is interrupted and not completed, some channels will not be received. Make sure to complete
p. 34
the Autoprogram.
The selected channel cannot be viewed by the Child lock setting.
The Unit requires some kind of Antenna Input. An indoor Antenna (Digital or VHF / UHF), an External Antenna (Digital or
VHF / UHF) or an RF Coaxial Cable from your wall Cable or Set-top Box needs to be plugged into the Unit.
Check if the correct Input mode is selected by pressing
Check the Antenna, Cable or other Input Connection to the Unit.
When using the Component Video Connection check that the Green (Y), Blue (Pb/Cb) and Red (Pr/Cr) connectors are
connected to their corresponding colored jacks on the Unit.
Many Digital channels have alternate channel numbers. The Unit changes the numbers Automatically to the ones signifying
the Broadcasting Station's channel number. These basic numbers used for the previous Analog Broadcasts. (e.g., Input
Digital ch# 30 Automatically changes to Digital ch# 8.1)
Closed Captions that are delayed a few seconds behind the actual dialog are common for Live broadcasts. Most captioning
production companies can display a dialog to maximum of 220 words per minute. If a dialog exceeds that rate, selective
editing is used to insure that the Closed Captions remain up-to date with the current TV screen dialog.
There is No clock function on this Unit.
Although the default PIN code (0000) is supplied with the Unit, the PIN code will be required once you set a PIN code in
p. 35 When you forget your PIN code, enter 07 1 1 in Change PIN to reset the PIN code.
Child lock.
When you start up the TV or a net service after executing the software update, a message may appear on the screen
prompting for software update again. In this case, please select Update to start USB update or network update.
p. 42
Answer
p. 51
p. 34
p. 35
p. 19
SOURCE.
48
.
English
p. 36
Continued on next page.