Setup And Projection - Eiki EIP-5000 Quick Manual

®
EIP-5000/5000L Quick Guide
This Quick Guide shows the basic operation (projector connecting with the
computer). Before using the projector, please read the Owner's Manual carefully.

Setup and Projection

1.
Place the projector facing a screen
2.
Connect the projector to the computer and plug the power cord
into the AC socket of the projector
3.
Remove the lens cap and turn the projector on
EIP5000_L_QuickGuide_JE.p65 2
3 8
5
5
4
3 8
4 6
4
7
6
6
6
4 6
7
Press on the projector or on the remote control.
4.
Adjust the angle
Adjust the projector angle
• • • • • Shift the lens horizontally and vertically.
1 Press
on the projector or on the remote control.
2 Press ', ", \ or | on the projector or the remote control.
5.
Adjust the focus and the zoom
1 Press
on the projector or on the remote control to adjust the focus.
2 Press
on the projector or on the remote control to adjust the zoom.
6.
Correcting the image distortion due to the projection angle
1 Press
on the projector or on the remote
control.
2 Press
on the projector or on the remote
control.
3 Press ', ", \ or | to move the position for the
upper left of the image.
7.
Select the input mode
Press on the projector or on the remote control
to select the "INPUT 1" mode.
•
When pressing on the projector, input mode switches in order of :
Pressing on the projector switches between "INPUT 4" and "INPUT 5".
•
When using the remote control, press / /
8.
Turn the power off
Press on the projector or on the remote control. While the confirmation message is displayed,
press or again.
" " On-screen Displa y " " "
•
You can unplug the power cord even if the projector is operating.
•
Even if you unplug the power cord from the AC outlet, the cooling fan continues to run for a while.
06.12.15, 13:34
• Adjust the projector angle by rotating the
adjustment feet.
4 Press
or to set the position.
5 Repeat the same procedure with the positions
for the upper right, lower right and lower left of
the image.
• When the position of the lower left is set, the
correction is made and the display disappears.
" " On-screen Display (RGB) "
INPUT 1 INPUT 2 INPUT 3
.
/ / to switch the input mode.
Printed in China
9NK5010060700
07P03-CH-NM