Lga 775 Cpu Installation Guide - Intel P43 User Manual

2-3-3

LGA 775 CPU Installation Guide

Socket Preparation
1. Opening the socket:
Note: Apply pressure to the corner with right hand thumb while opening/closing the load lever,
otherwise lever can bounce back like a "mouse trap" and WILL cause bent contacts (when
loaded)
Socket Load
Plate Open
2. Remove PnP Cap (Pick & Place Cap)
i. With left hand index finger and thumb to support the load plate edge, engage PnP cap with right
hand thumb and peel the cap from LGA775 Socket while pressing on center of PnP cap to assist in
removal.
ii. Set PnP cap aside. Always put PnP cap back on if the processor is removed from the socket.
iii. Visually inspect PnP cap for damage. If damage observed, replace the PnP cap.
3. Visually inspect for bent contacts (Recommend at least 1stpass visual inspection)
NOTE: Refer to the Handling and Inspection Module for 1stand 2ndpass inspection details.
NOTE: Glove images are for illustrative purposes only. Please consult local safety guidelines for
specific requirements
NOTE: Recommend not to hold the load plate as a lever, instead hold at tab with left hand, removing
the PnP cap with right hand
i.
hook to clear retention tab
ii.
135degrees
iii.
100degrees
Socket Load
Lever Open
Note: After PnP cap removal, make sure socket load plate
and contacts are free of foreign material; Refer to Overview
Module for FM cleaning.
Note: Optionally, remove PnP cap after CPU insertion. This
will compromise the ability to visually inspect socket.
Disengage Load Lever by depressing down and out on the
Rotate Load Lever to fully open position at approximately
Rotate Load Plate to fully open position at approximately
10