Cpu Installation - Intel G41 User Manual

(2) Keyboard/Mouse Power-on Enabled/Disabled: JP1
(3) USB Power-on Enabled/Disabled: JP2

2-3 CPU Installation

This motherboard provides a 775-pin surface mount, LGA775 Land Grid Array socket,
referred to as the LGA775 socket supports Intel Pentium Dual Core processor in the
775 Pin package utilizes Flip-Chip Land Grid Array (FC-LGA) package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to
prevent overheating. If this is not the case, then purchase a correct cooling FAN
before you turn on your system.
WARNING! 1.Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you
may install an auxiliary cooling FAN, if necessary.
2. Suggest the power of CPU should below 65w.
To install a CPU, first turn off your system and remove its cover. Locate the LGA775
socket and open it by first pulling the level sideways away from the socket then
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown
below. The notched corner should point toward the end of the level. Because the CPU
has a corner pin for two of the four corners, the CPU will only fit in the orientation as
shown.
JP1
1-2 Closed KB/MSPower ON Disable (Default)
Keyboard/Mouse Power On Setting
JP2
1-2 Closed: USB Power On Disable (Default)
6
JP1
2-3 Closed KB/MS Power ON Enabled
JP2
2-3 Closed: USB Power On Enabled
USB Power On Setting