Check Hydraulic Oil Level; Check Tire Pressures; Check Condition Of Belts; Lubricate Grease Fittings - Encore Prowler EP60MX800EV5 Operator's Manual

Table of Contents

Advertisement

CHECK HYDRAULIC OIL LEVEL

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Clean area around hydraulic reservoir cap and
remover cap. Oil level should be between 1/4"
– 3/4" when cold. Lower levels can result in
hydro damage/failure. Higher levels can result
in spillage from hot oil expansion. If necessary,
add SAE 20W50 motor oil. Replace hydraulic
reservoir cap and tighten until snug. Do not
over- tighten.

CHECK TIRE PRESSURES

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Check tire pressure.
3. Inflate drive tires to 12-14 psi (83-97 kPa).
4. Inflate caster tires to 15 psi.

CHECK CONDITION OF BELTS

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Look on the top side of the cutting deck to
check the mower blade drive belt condition.
3. Look under the engine deck to check the pump
drive belt condition.
4. Check all idler arms to be sure they pivot freely.

LUBRICATE GREASE FITTINGS

Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop
and remove key. Engage parking brake.
2. Lubricate fittings with NGLI #2 multi-purpose
grease.

CASTER WHEEL ROTATION

Service Interval: Every 200 hours
Removal and Installation
Remove nut and caster bolt. Pull the wheel out of
the fork. Install in reverse order. Tighten caster
bolt. Torque to 45 ft-lbs (61Nm), then back nut off
1/2 turn.
NOTE: Tire should rotate freely but axle spacers
should not.
If wheels do not rotate freely take the unit to the
dealer for service.
Lubrication Chart
FITTING
LOCATIONS
1. Deck Struts
2. Front Caster
Wheel Hubs
3. Front Caster
Pivots
4. HOC Arm
5. Deck Yoke
Pivot
6. Pivot Joints
(L & R)
7. Rear Deck
Shaft
8. Deck Yoke
Ball Joints
30
NUMBER
INITIAL
OF
PUMPS
PLACES
1
2
1
2
0
2
1
1
2
1
1
8
1
4-6
1
1
SERVICE
INTERVAL
Yearly
Weekly
Yearly
Weekly
Weekly
Weekly
Weekly
Weekly

Advertisement

Table of Contents
loading

Table of Contents