Troubleshooting - Zanussi ZCG43210BA User Manual

Table of Contents

Advertisement

To replace the glass panels, do the
same steps in reverse. Before you
lower the trim, attach the A trim part
to the door. Refer to the image.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
You cannot activate the appli-
ance.
The burners do not work.
There is no spark when you try to
activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
The flame colour is orange or yel-
low.
20
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
4. Install the glass cover.
Possible cause
The appliance is not connected
to an electrical supply or it is
connected incorrectly.
The fuse is released.
The appliance is too hot.
There is no gas supply.
Burner cap and crown are placed
incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
deactivate the circuit breaker.
The lamp glass cover is at the back
of the cavity.
to remove it.
°C heat-resistant oven lamp.
Use the same oven lamp type.
Check if the appliance is correct-
ly connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Wait for the appliance to cool
down.
Check the gas connection.
Place the burner cap and crown
correctly.
After lightning the flame, keep the
knob pushed for equal or less
than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
The flame can look orange or yel-
low in some areas of the burner.
This is normal.
Remedy
www.zanussi.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zcg43210waZcg43210xa

Table of Contents