Maintenance And Cleaning - Inalto IBF129S User Manual

MAINTENANCE & CLEANING
Defrosting
The bar fridge requires manual defrost. For efficient operation and minimum energy consumption,
defrost the chilling compartment when the frost on the chiller walls is building up. Do not let frost build
up to more than 3–4mm thickness. For efficiency, choose a time when your stock of frozen food is low.
• Unplug the power cord
• Please remove the foods from the refrigerator and place them properly to prevent foods from melting
or going bad, then prepare a water container for holding defrosting water.
• Pour the water in drain tray into the water container, and it is recommended to use a dry towel to dry
the defrosting water on liner and evaporator, then wring dry the towel. Repeat the operation until
defrosting completed.
• You can use the natural temperature of the natural defrosting, you can also use the ice shovel to
eliminate the frost (to use plastic or wooden ice shovel to prevent damage to the liner)
• You can also use the appropriate amount of hot water to speed up defrosting, with the dry towel to
dry the water after defrosting.
• Put all foods back and power on the appliance again.
Cleaning
WARNING
Before cleaning the appliance, make sure it is switched off and disconnected from the power supply.
Failure to do so can result in electric shock or injury.
• Wash the inside surfaces and the interior accessories with a damp, warm cloth moistened in a water
and baking soda solution. The solution should be about 2 tablespoons of baking soda to 1 litre of
water. Rinse and wipe dry with a soft cloth.
• Clean the outside of the unit with a damp, well wrung out cloth, keeping the area of the controls dry.
Keep the lid gasket (seal) clean.
• Never use boiling water to accelerate defrosting as it may damage the plastic components.
• Regularly check the appliance for defrost water. If necessary, clean the drain. If the drain is blocked,
water will collect in the base of the appliance.
• After cleaning/defrosting, push the drain plug in.
• After everything is dry, place appliance back into service.
• Allow approximately 1–2 hours for the cabinet to cool down again (depending on the length of time
the appliance was disconnected from the power).
WARNING
Never clean the unit with an abrasive, acid, oil or solvent based cleaning agent. Never use flammable
fluids or sprays for cleaning as the fumes from these substances can create a fire hazard or Explosion.
13