Inalto IBF129S User Manual page 10

Installation Cont.
Electrical connection
• WARNING!
It must be possible to disconnect the appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
• Before plugging in your new bar fridge, let it stand upright for at least 2 hours. This will allow the
refrigerant gases to settle into the compressor and reduce the possibility of a malfunction in the
cooling system.
• The appliance must be earthed. The plug of the power supply cord is equipped with a contact for
this purpose. Do not under any circumstances cut or remove the third (earth) prong from the power
cord.
If the plug does not fit your outlet, consult a licensed electrician for advice to have the outlet
changed.
• Plug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet voltage and
circuit frequency correspond to the voltage stated on the rating label.
• Secure the bar fridge's supply cord behind the unit. Do not leave it exposed or dangling to prevent
injury and accidental disconnection from the power supply.
• Adjust the temperature control as described below.
• When first starting up, and after a period out of use, allow the unit to cool down for at least 2–3
hours
(4 hours if starting up during warm weather in summer) before placing food in the bar fridge.
Reversing the door
• Remove the top hinge cover.
• Using a Phillips Head screwdriver, remove the top hinge assembly by unscrewing the hinge screws
that secure it.
• The door can now be removed off the bottom hinge.
• Using a flat blade screwdriver, remove the screw hole covers on the opposite side of the fridge and
door. Replace them to the side you just removed the top hinge from.
• Tilt the fridge back slightly in order to remove the bottom hinge assembly with a screwdriver.
• Unscrew the levelling foot on the opposite side.
• Reinstall the bottom hinge assembly and levelling foot to the opposite sides.
• Replace the door, correctly fitting it onto the bottom hinge.
• The top hinge bracket can now be installed on the new side and screwed in to secure.
• Finally, replace the hinge cover.
Defrosting pan
The defrosting pan (Fig. 1, A) is for any excess condensation
from the chilling compartment to drop into. Please check
on this for build-up and remove to clean if needed.
Moving the shelves
The three full size tempered glass shelves (Fig. 1, B) are
adjustable (Fig.1, C) to suit individual storage requirements.
A
B
B
C
B
10
Fig. 1