Radio; Listening To The Radio; Manual Storing Of Station Presets; Automatic Memory Of Station Presets - Alpine IVA-D105R Owner's Manual

Radio

Display example for MW Radio main screen
Displays the preset number/frequency.

Listening to the Radio

1
Press SOURCE/
.
The SOURCE selection screen is displayed.
2
Touch [RADIO].
The radio mode is activated and the display changes to the
Radio Mode screen.
3
Touch [BAND] to select the desired radio band.
Each press changes the bands as follows:
FM-1 FM-2 FM-3
4
Touch [TUNE] to choose the tuning mode.
Each touch changes the tuning mode display.
Distance Local
• There are two modes you can select for auto tuning, DX and
Local:
- DX (Distance) mode (with DX SEEK indicator ON);
Both strong and weak stations will be tuned in.
- Local mode (with SEEK indicator ON);
Only strong stations will be tuned in.
The initial setting is DX.
5
Touch [ ], [ ] or [
radio frequency up or down respectively.
When touched and held in the manual mode, the frequency
changes continuously.
MW LW FM-1
Manual Distance
], [ ] to change the

Manual Storing of Station Presets

1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Touch [PAGE1/2] to change the function guide.
3
Touch and hold any one of the preset buttons [P-1]
through [P-6] for at least 2 seconds.
The selected station is stored.
4
Repeat the procedure to store up to 5 other stations
onto the same band.
To use this procedure for other bands, simply select the
band desired and repeat the procedure.
A total of 30 stations can be stored in the preset memory (6
stations for each band; FM1, FM2, FM3, MW and LW).
• If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.

Automatic Memory of Station Presets

The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
After selecting the desired band, touch [A.MEMO].
The tuner automatically seeks and stores 6 strong stations into
[P-1] to [P-6] in order of signal strength.
When the automatic storing has been completed, the tuner goes
to the station stored in [P-1].
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.

Tuning to Preset Stations

You can tune in the preset stations in memory on each band using the
preset number.
1
After selecting the desired band, touch [PAGE1/2]
to change the function guide.
2
Touch any one of the preset buttons [P-1] through
[P-6] that has a station stored to it.
The preset station is received.
13
-EN