7
Bottom view
4: Antenna connectors (MSM466 only), Radio 1 right, Radio 2 left
5: Reset button
6: Cable channel
Status lights
The status lights provide different information depending on whether the AP is operating in
autonomous mode or controlled mode. For more information on these modes, see
mode and autonomous mode" (page
Autonomous mode
In autonomous mode, the status lights indicate the following:
Light
State
Power
Off
On
Blinking
Ethernet
Off
Blinking
Radio
Blinking
6
Preparing for installation
4
4
5
6
8
9
15).
Description
The AP has no power.
The AP is fully operational.
The AP is starting up. If the Power light continues to blink after several minutes, it indicates
that the software failed to load. Reset or power cycle the AP. If this condition persists,
contact HP Support.
The port is not connected or there is no activity.
The port is transmitting or receiving data.
The radio is transmitting or receiving data.
7
7: AP Bracket tab slot
8: Console port
9: Ethernet port
"About controlled