Table of Contents
Advertisement
Removal
Removing the oven door See the section Removing the oven
1.
door. Lay the oven door on a cloth with the handle facing
downwards.
Remove the cover from the top of the oven door. To do this,
2.
press with your fingers on the left and right-hand side. Pull
out the cover (Fig. A).
Raise the top panel and pull it out (Fig. B).
3.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If your meal is not successful, please refer to section . We have
tested the recipe for you in our cooking studio. Here, you will
find useful cooking tips and tricks for cooking, baking and
roasting.
:
Risk of electric shock!
Repairs that are not carried out properly are dangerous.
Repairs must only be performed by one of our after-sales
service technicians.
Malfunction
Possible cause Remedy/information
The oven does
The circuit
not work.
breaker is
defective.
Power cut.
Oven not hot.
Dust on the
contacts.
The burner
Power has
does not ignite.
failed or igni-
tion plugs are
damp.
Look in the fuse box to see
if the circuit breaker is
defective.
Check whether the kitchen
light and other kitchen
appliances are working.
Turn the control knobs sev-
eral times to the left and
right.
Light the gas burner with a
gas lighter or a match.
Fitting
Hold the top glass panel firmly by the sides and slide it in
1.
towards the back at an angle. The panel must be inserted
into the openings on the lower side. The smooth surface must
face outwards, while the roughened side must be on the
inside. (Fig. A).
Place the cover on the top of the oven door and press in
2.
place. Make sure that the grooves along the sides lock into
position.
Refitting the oven door See the section Refitting the oven
3.
door.
Do not use the oven again until the panels have been
correctly fitted.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 25 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent damage.
1.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Glass cover
You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
19
Advertisement
Table of Contents
