802.1X Setting-Certification - Edimax EW-7618Ug User Manual

3.2.1.3 802.1x Setting-Certification

Parameter
Authentication Type
Session Resumption
Password
Use Client Certificate
Tunneled Authentication
Protocol
Identity
Password
Description
The EAP authentication protocols this adapter has supported are
included as follows. This setting has to be consistent with the
wireless APs or Routers that the adapter intends to connect.
PEAP &TTLS – PEAP and TTLS are similar and easier than TLS
in that they specify a stand-alone authentication protocol be used
within an encrypted tunnel. TTLS supports any protocol within its
tunnel, including CHAP, MS-CHAP, MS-CHAPv2, PAP and
EAP-MD5. PEAP specifies that an EAP-compliant authentication
protocol must be used; this adapter supports EAP-MSCHAP v2,
EAP-TLS/Smart Card and Generic Token Card. The client
certificate is optional required for the authentication.
TLS/Smart Card –TLS is the most secure of the EAP protocols
but not easy to use. It requires that digital certificates be
exchanged in the authentication phase. The server presents a
certificate to the client. After validating the server's certificate, the
client presents a client certificate to the server for validation.
There are "Disabled", "Reauthentication", "Roaming", "SameSsid"
and "Always" selections for you to choose whether to recovery the
session in different status.
Enter the password as the identity for the server.
A client certificate is required for TLS, and is optional for TTLS and
PEAP. This forces a client certificate to be selected from the
appropriate Windows Certificate Store and made available to the
RADIUS server for certification.
When the authentication type is PEAP or TTLS, select a protocol
to be used to build the encrypted tunnel.
This is the protected user EAP Identity used for authentication.
The identity specified may contain up to 63 ASCII characters, is
case sensitive and takes the form of a Network Access Identifier,
consisting of <name of the user>@<user's home realm>. The
user's home realm is optional and indicates the routing domain.
The password used for authentication. It may contain up to 63
ASCII characters and is case sensitive.
17