Toshiba MMD-AP0076BHPUL Service Manual page 92

No. Part name
Heat 1. Detachment
exchanger
1) Recover the refrigerant gas and then
2) Perform works of 1 of
3) Pull out TC sensor and TCJ sensor wirings
4) Remove the screws (Ø4 x 8, 2 pcs.) and
5) Remove screws (Ø4 x 8, 1pc.) of the heat
6) While holding the heat exchanger, remove
2. Attachment
1) Set the heat exchanger at the original
2) Enter TC sensor and TCJ sensor wirings in
3) Attach the drain pan and the bottom base
Procedure
remove the refrigerant pipe of the indoor
unit.
.
from the holder.
then remove the piping cover.
exchanger fixed plate.
the fixed screws (Ø4 x 8, 2 pcs.) of the end
plate and then take out the heat exchanger
slowly.
position and fix it as before, using screws
which removed the end plate, heat
exchanger fixed plate and piping cover.
the holder and then perform wirings as
original.
as original.
AP007 Type
AP015 Type
AP024 Type
- 92 -
Remarks
: Screw position
Heat exchanger
End plate
fixed plate
Piping cover
Heat exchanger
fixed plate
End plate
Heat exchanger
fixed plate
Piping cover
End plate
Piping
cover