Furnace - Roadtrek 190 Popular Owner's Manual

Hide thumbs Also See for 190 Popular:
Table of Contents

Advertisement

Heat Pump (Continued)
Turn fan to the ON position.
Adjust the thermostat on the unit for the desired temperature. The compressor should start automatically.
Your vehicle should be parked as close to level as possible to maximize the air conditioner's efficiency. If you are parked very much off-level,
it is possible for condensate to leak into the living space. If this happens park in a more level location.
You can use the heat pump to warm the motorhome on cool nights. For colder temperatures, below 40°F (4°C), you should use the propane

furnace.

Furnace
The furnace is controlled by the combination thermostat located above the rear bed. (Picture 52.1) The furnace requires propane and 12 volt power.
The furnace uses much less electricity compared to the heat pump, and can be used without shore power or generator use.
The fan on the furnace is thermostatically controlled, and will continue to run for a minute or so after you turn it off until the firebox cools down.
Keep the aisle in front of the furnace clear of any obstructions when using the furnace to allow air circulation.
The furnace can operate when outside temperatures are below freezing.
Picture 52.1
© Erwin Hymer Group North America, Inc., R00
52

Advertisement

Table of Contents
loading

This manual is also suitable for:

210 popular 2018

Table of Contents