Troubleshooting; Troubleshooting Guide; Care And Maintenance; Stored Data Management - NEC AT-50P User Manual

TROUBLESHOOTING

Troubleshooting Guide

Problem
No dial tone /Will not dial out
Phone does not ring
Cannot be heard by the other party

Care and Maintenance

To keep your telephone working well and looking good, follow these few simple guidelines.
 Avoid putting the telephone near heating appliances and devices that generate electrical noise.
 The telephone should not be exposed directly to sunlight or moisture.
 Avoid dropping the handset and other rough treatment.
 Clean the telephone using a soft cloth moistened with a mild cleaning solution. Remove all
traces of the cleaner with a damp cloth.
 Never use cleaners containing alcohol, strong cleaners that may corrode plastic, or abrasive
powders, as this may damage the finish.

Stored data management

This telephone records the telephone number. When you stop managing this telephone, it is
recommended to restore to factory setting. When it's restored to factory setting, all data recorded in
this telephone is cleared.
Please refer to "Feature Access Code" on page 13 for how to do "Restore to Factory Settings".
 Check that the hook switch is not depressed.
 Check that the line cord is connected.
 Ensure that the Dialing Mode Switch is set to the correct position.
 Unplug the phone, wait 30 seconds, then plug the phone back in.
 Ensure there are no other devices connected to the same line.
 Confirm phone cord and handset curly cord are securely plugged in.
 Make sure MUTE key LED is off.
11
TROUBLESHOOTING
Solution