EdgeStar IW400SS User Manual

Read all of the instructions before using this appliance. When using this appliance,
always exercise basic safety precautions, including the following:
•
Do not plug this appliance into the power socket before set up is completed.
•
Do not use if the power supply cord is damaged. If damaged, it must be replaced by a
qualified technician.
•
Do not use this appliance with an extension cord or power strip. Please ensure that the
appliance is plugged directly into the electrical outlet.
•
Do not run the power cord over carpeting or other heat insulators. Do not cover the
cord.
•
Do not submerge in water.
•
Do not cut or remove the third prong (the grounding prong) from the power cord.
•
The cord should be secured behind the unit and should not be left exposed or dangling.
•
Never pull the power cord to disconnect it from the outlet. Grasp the plug directly and
pull it from the outlet.
•
Never lift or carry the unit by the power cord.
•
Use extreme caution when using hot water dispenser. Do not let hot water touch
bare skin. Exercise caution and use reasonable supervision when appliance is
used near children.
•
This unit is intended for indoor use only.
•
For stable installation, make sure the cooler is placed on a flat, level, and solid surface.
•
When positioning the Ice Maker with Water Dispenser, ensure that there is at least a 2"
clearance at the sides and at least 4" clearance at the back of the unit. This will allow for
adequate ventilation of heat from the back of the unit.
•
Avoid subjecting the cooler to external heat sources or direct sunlight.
•
Do not tip over the unit.
•
The Ice Maker with Water Dispenser is an electrical appliance. To avoid injury or death
from electrical shock, do not operate the water dispenser with wet hands, while
standing on a wet surface, or while standing in water.
•
Do not use any liquid other than water in the dispenser or to make ice.
•
Always turn off the unit and unplug it when there is no water left in a bottle or when
changing a bottle. Turn it back on after a new bottle has been installed and purge
excess air from the water dispenser buttons.
•
Unplug the unit before cleaning or making any repairs.
•
Do not clean the unit with flammable fluids. The fumes can create a fire hazard or
explosion.
•
Disconnect the unit when not in use.
•
This appliance is designed for non-commercial use only.
•
Performance may vary depending on operational conditions.

SAFETY PRECAUTIONS

1