EdgeStar KC2000 User Manual

EdgeStar KC2000 User Manual

Draft beer dispenser

Advertisement

Read all of the instructions before using this appliance. When using
this appliance, always exercise basic safely precautions, including the
following:
• This appliance is designed for household use only and not for commercial
use. Do not use the appliance for uses other than that for which it is
designed.
• Do not use the appliance if the power supply cord is damaged. If the
power supply cord is damaged, it must be replaced by a qualified
technician.
• This unit is designed to function on 115 Volts/ 60 Hz (110/115/120 Volts
acceptable) electrical circuits.
• This appliance is not designed for children. Never allow unattended
children to use this appliance.
• Unplug the appliance if it will not be used for an extended period of time.
• Unplug the appliance prior to cleaning.
• Set the appliance on a level surface away from direct sunlight and other
heat sources.
• This appliance is designed to function optimally in room temperature
environments (mid 70°s Fahrenheit).
• Do not move the unit while it is full.
• The power supply cord must be grounded.
• Never pull the power supply cord directly to disconnect the appliance.
Always pull the plug out of the socket.
• Never lift the appliance by the power supply cord or the dispensing tap.
• Keep the power supply cord away from heating surfaces.
• Service only by authorized technicians.
• Do not immerse the appliance or its power supply cord in water or any
other liquid.
• Do not cover the appliance or place anything on it.
• Do not insert any objects into the ventilation holes.
• Only use approved CO
the procedures for the CO
• Cylinders contain pressurized CO
in a dry and cool place. CO
regulator! Failure to do so may cause an explosion resulting in possible
death or injury when the cylinder valve is opened.
• Do not dispose of empty CO
cylinder.
• Clean this appliance regularly, and after every keg.
• If you are replacing an older appliance with this unit, take care to remove
the door of the old appliance before throwing it away. This will alleviate the
risk of child entrapment.

SAFETY PRECAUTIONS

cylinders. Make sure you read and understand all
2
cylinders before installation.
2
cylinders should always be connected to a
2
cylinders in a fire. Never drop or throw a CO
2
. Keep them away from heat, and store
2
2
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KC2000 and is the answer not in the manual?

Questions and answers

Summary of Contents for EdgeStar KC2000

  • Page 1: Safety Precautions

    SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safely precautions, including the following: • This appliance is designed for household use only and not for commercial use. Do not use the appliance for uses other than that for which it is designed.
  • Page 2: Welcome And Thank You

    Welcome and Thank You Welcome and Thank You Welcome and thank you for purchasing this EdgeStar Daft Beer Dispenser. We are glad you choose us and we take pride in knowing that like our products our customer service will be just as dependable. Once you complete our easy unit set up by following the manual, it will provide you years of great service.
  • Page 3: Table Of Contents

    DISPENSING THE BEER & DRAW TECHNIQUE…………………………...……10 BEER CLEAN GLASSES……………………………………………………………..10 UNDERSTANDING BEER TEMPERATURE……………………………………….11 UNDERSTANDING THE TEMPERATURE CONTROL SETTING………………12 AUTOMATIC DEFROSTING…………………………………………………………12 UNDERSTANDING NORMAL OPERATING SOUNDS…………………………...12 BEER SERVING GUIDE……………………………………………………………...12 CONVERTING THE BEER DISPENSER TO AN ALL-REFRIGERATOR APPLICATION………………………………………………………………………...13 CLEANING AND MAINTAINING YOUR DRAFT BEER DISPENER …………..13 TROUBLESHOOTING……………………….…………………………………...14-16 LIMITED WARRANTY…………………………………………………………...16...
  • Page 4: Unpacking Acessories And Inventory

    Suggested accessories include: A cleaning kit Different types of taps And more… For more information on compatible accessories, feel free to email service@edgestar.com or call toll-free 866-319-5473. Proper Location • To guarantee that your Draft Beer Dispenser will last for years to...
  • Page 5: Assembly Instruction

    Note: You should store this plug in a safe place as it is required to convert the beer dispenser into a refrigerator 2. Take the tower and untangle the tubing. From the top of the unit, feed the tubing through the hole and into the unit.
  • Page 6: Installing The Co

    2. Remove the plug located at the exterior back. Save it for later in case you decide to convert the unit into an “all refrigerator.” Run the other end of the CO through the open hole through the inside of the cabinet.
  • Page 7: Installing The Keg Coupler-Tapping The Beer

    Your beer dispenser comes with American Sankey Tap. Before purchasing a keg, check with your beer distributor to make sure that supplied American Sankey Tap can be used. Many European beers require a different tap. Please contact EdgeStar customer service online via email at service@edgestar.com or by telephone at 1-866-319-5473 for more information.
  • Page 8: Operating Your Beer Dispenser

    OPERATING YOUR BEER DISPENSER Grounding Instructions Grounding Instructions • This appliance’s plug must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. •...
  • Page 9: Setting The Regulator

    Setting the Regulator EdgeStar’s Draft Beer Dispenser comes with a single gauge CO 0-60 lb. pressure gauge showing the gas output pressure. Once the regulator is securely attached to the gas cylinder: 1. Close the shut-off valve on the regulator, and open the valve on the cylinder completely.
  • Page 10: Dispensing The Beer & Draw Technique

    Beer Clean Glasses We recommend that you reserve a set of glasses specifically to the enjoyment of your EdgeStar Draft Beer Dispenser. Do not wash beer glasses together with glasses that have contained milk or any other fatty substances. Using a glass for anything else may leave residues that are extremely hard to get rid of.
  • Page 11: Understanding Beer Temperature

    Such thermometers are enclosed in a casing filled with liquid; this provides a constant accurate reading of the liquid (beer) temperature within the refrigerator. Contact EdgeStar customer service online via email at service@edgestar.com or by telephone at 1-866-319-5473 for more information.
  • Page 12: Understanding The Temperature Control Setting

    Understanding the Temperature Control Setting The temperature control is located inside the unit in the upper left-hand corner. After turning the unit on, you must wait 24 hours for the unit to cool properly. You may then adjust the temperature setting based on your needs and preferences. Automatic Defrosting It is not usually necessary to defrost the beer dispenser.
  • Page 13: Converting The Beer Dispenser To An All-Refrigerator

    A few minutes spent cleaning on a regular basis will add life to your system, and improve the quality of your draft beer! FOR INFORMATION ON PURCHASING CLEANING KITS PLEASE CONTACT EDGESTAR CUSTOMER SERVICE ONLINE VIA EMAIL AT service@edgestar.com OR BY TELEPHONE AT 1-866-319-5473.
  • Page 14: Troubleshooting

    TROUBLESHOOTING Problem Excess formation of foam “head.” Beer, when drawn is all foam, or too much foam and not enough liquid beer. Flat Draft, no formation of foam. Foamy head disappears quickly; beer lacks usual zestful brewery fresh flavor No beer flow from dispenser Possible Causes Recent keg agitation...
  • Page 15 Closed CO shut-off valve. Empty beer keg. Line or dispenser obstructions. Improper connections(s) Sputtering Draw Dispense system requires cleaning. Keg Coupler installed incorrectly Line or dispenser obstructions. Improper draw technique Faucet Dripping Handle not fully returned to close position. Faucet requires cleaning Rapid CO cylinder Improper connection, air...
  • Page 16: Limited Warranty

    DESCRIPTION OF WARRANTY SERVICE: All defective product components covered by this warranty will be repaired or replaced, at EdgeStar’s option, free of charge on a mail-in basis to EdgeStar’s authorized repair facility during the first 90 days from the date of original purchase.
  • Page 17: Obtaining Warranty Service

    Once an EdgeStar authorized representative has confirmed that your product is eligible for warranty service, the product must be returned to our EdgeStar repair facility. The purchaser is solely responsible for prepaying all shipping related costs to and from the repair facility.

This manual is also suitable for:

Kc2000ssKc2000cleanKc2000hmbrew

Table of Contents

Save PDF