Starting Warm Engine - Echo SRM-2620U Operator's Manual

SRM-2620U
Lay the unit on a flat area and keep movable attachment parts clear of all
obstacles. Firmly grasp throttle handle and throttle trigger lockout with left
hand and fully depress throttle trigger to wide open position. Rapidly pull
recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).
5. Choke
After engine fires (or 5
pulls), move choke lever
back to RUN
position. Firmly grasp
throttle handle and throttle
trigger lockout with left
hand and fully depress
throttle trigger to wide
open position. Pull recoil
starter handle/rope until
engine starts and runs.
Release throttle trigger,
and allow unit to warm up at idle for several minutes.
Note: If engine does not start with choke in "RUN" position after 5
pulls, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, grip throttle handle and support handle. Depress
the throttle trigger lockout, and gradually depress throttle trigger to
increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as
Cold Start except DO NOT close the
choke, and do not hold throttle trigger
fully depressed.
The attachment should not move
at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
"Carburetor Adjustment" instructions in this manual or see
your ECHO Dealer.
1. Stop Switch
X7502341900
© 10/2016 ECHO Inc.
( )
D
OPERATION
A
31